This laminated boat for sale is located in Bodrum, Turkey. The Gulet is laminated hull, recently upgraded transom stern Gulet.
Details of the hull is as fallowing:
Applied 3 x 3 mm cross layer on top of 40 mm current planking. Completed with epoxy glass-fiber.
Frames 150 x 100 mm and the space in between frames 200 mm. Stringers 200 x 50 mm.
The Gulet is powered with 330 HP Scania (D1946, & CYL.) main engine. The engine is on 1400 hrs. July 2018. It is replaced in 2005.
Rigged with 2 aluminum masts, stainless steel wires and fittings. The main mast has in-mast furling system. Genoa and jib has
furling system as well. 3 set of Dacron brand sails allows good performance.
The Gulet accommodated with 4 cabins(2 master and 2 double). 3 of the cabins are ensuite. Galley is in the saloon. But if no need 4 cabins,
one of the double cabin next to the saloon can be converted into galley and the saloon can be re-designed. It is just a small advice.
Crew cabin: There is one simple bunk in the fore peak which is not being used for the crew as the owner store a lot of things there.
Therefore, the crew use the port /or starboard amidships cabin.
The Gulet was upgraded in 2016 and 2017. Works done are as fallowing:
• Starboard cabin and partly the teak deck next to the windlass is upgraded.
• The masts were repainted (white).
• The hull paint is scraped and re-primer and antifouling applied in August 2017.
• Sea valves are checked and mostly renewed.
• The stern tube bearing, shaft seal and vibration damper is renewed and the shaft with propeller checked in Izmir by a specialist.
• Scania main engine has serviced at 1000 hrs.
• Coolers, pumps, turbo, generator, starter motor removed and overhauled.
• Fuel pump plungers and injectors are renewed.
• Steering gear removed and overhauled.
• Bow spirit is replaced.
• Renewal of a main engine exhaust.
• New safety relays for low pressure pump for the water maker.

Gulet Details for pdf